CB T295 Marine Mushroom Ventilation

CB T295 Marine Mushroom Ventilation


CB T295 Marine Mushroom Ventilation has a ring of water retaining grooves around the periphery; one side of the water retaining groove is open, and at the bottom of the opening a short pipe is connected; the short pipe is connected to the drain pipe, which is bent to the side of the wind turbine; at the bottom of the drain pipe there is a water retaining plate. The diameter range is DN150-1400.


Overview

Marine Mushroom Ventilation flushing experiment

With a diameter of not less than 12.5 nozzle, water pressure of not less than 0.25Mpa, and then not more than 1.5mm from the ventilation cylinder for flushing, flushing time 3min, the results should be consistent with the "parts of the water beads, sealing packing and wind tube contact indentation width of not less than 0.5t (t for the thickness of the wind tube tube .

Marine Mushroom Ventilation indentation experiment

In the wind and rain sealing packing, evenly coated with white powder, close the wind and rain cover, and then open, check the sealing packing and wind tube edge contact indentation width, the results should be consistent with the requirements of 4.7.

Drawing:

CB T295 Marine Mushroom Ventilation3.jpg

Picture:

CB T295 Marine Mushroom Ventilation2.jpg

Table:

Name of the part

Material

Name

Mark

Standard

Ventilator

Steel

Carbon Steel

Grade A

Q235-A

GB712-2000

GB/T 700-1988

Fireproofing

Stainless Steel

Cr18Ni9

H68

GB/T 1220-1992

GB/T5232-1985

Screw

Brass

H62

GB/T5232-1985

Hand wheel

Forged/Cast Steel

KHT300-06

Q235-A

GB/T9440-1988

GB/T700-1988

 

Sealing

NBR

Tensile strength not less than 14.7Mpa, hardness HA35-45

Trigging helix

Carbon Steel

Q235-A

GB/T700-1988


Contact Us